12
ASSEMBLY
STEP 4
4a. Hardware Removal: Remove f
our
Hex Bolt (42),
four
Spring Washers (52)
and four
Flat
Washers (14)
from the
Handlebar Post (5)
4b. Installing the Front Post to the Main Frame:
Loosen the
Spring Knob (25)
by turning it
Counter-Clockwise then
pull
Spring Knob (25)
out,
insert the
Handlebar Post (5)
into the
Main
Frame (1)
, release the
Spring Knob (25),
Press down on the
Handlebar Post (5)
until it
“Pops”
into one of the adjustment holes and tighten the
Spring Knob (25) Clockwise.
TIP :
When adjusting the height of
Front Post (5),
the
STOP
line cannot be higher than
the edge of the plastic bushing.
4c. Installing the Handlebars to the Front Post:
Attach the
Handlebar (7)
onto the
Front Post
(5)
. Secure the
Handlebar (7)
with four
Hex Bolt (42),
four
Spring Washers (52)
and four
Flat
Washers (14)
that were previous removed then fully tighten with the
6mm Allen Wrench with
Phillips Screwdriver
provided.
(42) Hex Bolt
4PCS
Pre-Installed Hardware:
6mm Allen Wrench with
Phillips Screwdriver
1PC
TOOL:
(14) Flat Washer
4PCS
(52) Spring Washer
4PCS
