10
Step 1
1a Frame Set Up:
Pull apart the
Front Frame (2)
and the
Rear Frame (1)
. Rest the
Rear Frame
Support Tube (67)
into the curved bracket near the bottom of the
Rear Frame (1)
. Align one of the
two pin holes where the
Front Frame (2)
and
Rear Frame (1)
intersect and insert the
Safety Pin
(22)
to lock the frames in place. The pin holes can be found by tracing the reference lines of the
Safety Pin (22)
in the above illustration. Lower the
Console Support Tube
(87)
until it aligns with
the lowest hole on the
Rear Frame (1)
bracket. Then insert the
Pin (107)
to lock the
Console
Support Tube
(87)
in place. Trace the reference line of the
Pin (107)
in the illustration to see where
the aligned bracket is.
1b Rear Stabilizer Installation;
Attach the
Rear Stabilizer (3)
with the transport wheels onto the
rear curve of the
Rear Frame (1)
using two
Carriage Bolts (110)
, two
Hexagon Nut Caps (29)
,
two
Spring Washers (102)
and two
Curve Washers (30)
. Use the provided
13-15mm Wrench
to
tighten all the bolts and caps until they are firm and secure.
1c Front Stabilizer Installation:
Attach the
Front
Stabilizer (31)
onto the front curve of the
Front
Frame (2)
using two
Carriage Bolts (110)
, two
Hexagon Nut Caps (29)
, two
Spring Washers
(102)
and two
Curve Washers (30)
. Use the provided
13-15mm Wrench
to tighten all the bolts and
caps until they are firm and secure.
Tool:
13-15mm Wrench
1PC
Hardware:
(30) Curve Washer
4 PCS
(110) Carriage Bolt
4PCS
(102) Spring Washer
4 PCS
(29) Hexagon Nut Cap
4 PCS
(22) Safety Pin
1PC
(107) Pin
1PC
ASSEMBLY
Rear Stabilizer (3)
Transport Wheels
Summary of Contents for 525XLR
Page 5: ...3 LABEL PLACEMENTS...
Page 8: ...6 OVERVIEW DRAWING...
Page 11: ...9 HARDWARE TOOLS PACK...
