GG0261
UM0034 Rev K
2
LS-1130 FLASHPAC OPERATION MANUAL
1.
INTRODUCTION
1.1. DESCRIPTION
The
LS-1130 FlashPac
is an integrated light system that requires only external
power and control connections for operation. Its internal circuitry provides power to
the discharge capacitor as well as output voltage control and triggering.
The standard fiber-optic cable adapter accepts 1.00" diameter (nominal) sub-
adapters such as the MVS-14-2 or MVS-20 to accept various cable configurations
(see Table 5). Please consult the factory regarding other custom options.
1.2. UNPACKING
If the condition of the outer packaging suggests mishandling has occurred, examine
the LS-1130 for any signs of breakage during shipment. If there are any obvious
signs of damage, contact the carrier immediately and do not proceed with the
installation. It is recommended that the packaging material be retained and stored in
the event that the unit has to be reshipped.
2.
INSTALLATION
2.1.
MOUNTING (SEE FIGURE 1)
Mount the unit in a protected position, without restricting air flow through its
ventilation openings, by using two #6 clearance holes in the base of the enclosure.
Mounting hardware is user-supplied.
2.2. SAFETY
REQUIREMENTS
Use
Input Receptacle, J1
(on the right) as a disconnect
device to remove any possibility of electrical input,
particularly, when accessing the unit’s interior. Orient the unit
so that J1 is accessible.
Protect the usit by coneecting user’s ground to pin 8 of
Input Receptacle, J1.
Be careful not to touch the strobe output window, which gets very hot.
The window will break if treated in a manner inappropriate for glass.
1 2 3 4 5
6 7 8 9
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
