Excelitas Technologies 019-00187R, User Manual

Page: 9 / 29

5
035-00540R-r4
4 Getting Started
4.1 Packaging Contents
Your package contains one of the following UV LED Heads, as well as a documentation CD:
Model Optical Length Part Numbers
365nm Wavelength 395nm Wavelength
AC7150 150 mm 019-00197R 019-00198R
AC7300 300 mm 019-00187R 019-00196R
Carefully unpack the unit and store the packing material for future use.
4.2 System Requirements
In addition to the UV LED Head, you will require the following components:

Power supply

Power cable
You will also require a PLC controller unless you are using an existing controller. The PLC controller is used to
discover the extensive functionality of the UV LED head. Integrators can access the full feature set through
integrating with the PLC interface directly. Refer to
Section 6.1 .
These may be sourced separately or may be purchased from Excelitas Technologies. Check with Excelitas
Technologies to determine the appropriate components for your requirements. The following table provides
the part numbers of recommended component parts, as well as a part number to order all components as a
package.
AC7150-365nm AC7150-395nm AC7300-365nm AC7300-395nm
UV Head 019-00197R 019-00198R 019-00187R 019-00196R
System Controller 019-00195R 019-00195R 019-00199R 019-00199R
DC Power Cable 018-00559R 018-00559R 018-00559R 018-00559R
PLC Controller 019-00214R 019-00214R 019-00214R 019-00214R
Package (all components) 010-00334R 010-00335R 010-00336R 010-00337R
Other units are available for different purposes; check with Excelitas Technologies to determine the
appropriate components for your requirements.
4.3 Connecting the Power Supply and PLC Controller
Note : All connectors are via screw style fastener -- do not over tighten the connector screws.
Note : The following is a generic procedure, illustrated with the common components described above;
please refer to specific documentation related to your power supply and controller.
Tip : After securing the power cable to the power supply, it is recommended to “tie-off” the female
connector cable on to the mounting brackets or process rigging as a form of strain relief.
1. Make sure the power supply unit is turned off.
2. Connect the AC power cord to the power supply