Page | 3
SAFETY INSTRUCTIONS
During use of the infrared heater, it is necessary to observe some precautions. Improper
operation with disregard of precautions may result in infliction of harm to health of the user
and other people, as well as in infliction of damage to their property.
Use only the voltage specified on the rating plate of the heater.
ONLY connect the appliance to a properly installed socket-outlet with earth contact.
The heater should be connected to the electric mains equipped with an automatic circuit
breaker.
The unit must be handled with care, and avoid vibration or hitting.
WARNING: FIRE RISK EXISTS IF THE HEATER IS COVERED BY OR POSITIONED
CLOSE TO CURTAINS OR OTHER COMBUSTIBLE MATERIALS.
Do not use the appliance areas where gasoline, paint, explosives or other flammable
liquids are used or stored.
Do not use the appliance in a building site, green house, barn or in animal stables.
Do not use the appliance as a sauna heater.
Do not use this unit in the place of animal propagating and rising.
WARNING:
Do not touch the radiating plate. Temperature of radiating boards during
operation of the heater may reach 380 °C. To avoid burns, do not touch the appliance
surface by hand and other body parts. It is also necessary to avoid touching the heater
whilst the appliance is switched on, as severe burns may result. The appliance can take
up to 1 hour to cool down after switching it off.
Do not place any items of clothing, hand towels or similar over the heater to dry. Risk of
overheating and fire hazard.
Do not leave the heater unattended whilst in use.
Do not use this heater on a wet surface, or where it can fall or be pushed into water.
Do not reach for an appliance that has fallen into water. Switch off at supply and unplug
immediately.
If the supply cord is damaged, it must be replaced by a licensed electrician.
If the heater is defective, it must be returned to the place of purchase.
Do not operate appliance with wet hands.
Use this appliance only as described in this manual. Any other use is not recommended
by the manufacturer and may cause fire, electric shock or injury.
Do not use abrasive cleaning products on this appliance. If the body becomes dirty, wipe
off dust with a cloth, and the radiating boards should be wiped in cold condition with a
damp soft cloth. Always remove plug from the mains supply before cleaning.
The heater must be installed at least 2.2 m above the floor.
The heater must not be located immediately below a socket-outlet. Socket-outlet should
not be located at the back of the heater. They should be located outside the physical
footprint of the units to minimize heat build-up behind the heater.
