4. Direction
4.1 Preparation
4.2 Remove the jacket of cables for uncut fibre installation
4.3 Removal of the single cable jacket
4.4 Installation of the fibre closure
4.3.1 Mark the point on the cable; the length of stripping is about 180cm from the end.
4.3.2 Remove the jacket
4.3.3 Cut off the extra reinforced core about 5cm from the removing point on the sheath.
Tools as following:
4.1.1 Please check the structure and type of the cable before installation. Different types of fibre can’t be spliced together.
4.2.1 Mark the point on the cable, the length of stripping is about 180cm.
4.2.2 Remove the jacket from the marked point with a sheath stripper
4.2.3 Cut off the extra reinforced core about 4cm from the removing point on the sheath.
NOTE: 1. Be sure not to damage fibre
2. Do not use any damaged cable
3. While removing the cable sheath, please do not cut, twist or damage cable jacket. Reserve enough length to
ensure repair and maintenance in case of any accidents.
NOTE: 1. Be sure not to damage fibre
2. Do not use any damaged cable
3. While removing the cable sheath, please do not cut, twist or damage cable jacket.
Reserve enough length to ensure repair and maintenance in case of any accidents.
4.1.2 Ensure all seals are mounted correctly and take care not to over tighten.
4.1.3 Keep the working place free from moisture and dust. Don’t give any impact on the cables and don’t bent or entwine cables.
4.1.4 Use appropriate tools according to the approved standard of fibre optic splicing in your region when remove the jacket of
cables and assemble the closure.
