10
Installer Programmable Features (cont’d)
Feature #11 Turbo Timer
Off
(press the brake pedal 1 time to program)
- DeFauLT
run 1 Minute
(press the brake pedal 2 times to program)
run 2 Minutes
(press the brake pedal 3 times to program)
run 3 Minutes
(press the brake pedal 4 times to program)
This feature when turned on configures the system to automatically keep the engine
running briefly after it is turned off. This operation is designed specifically for ve
-
hicles having turbocharged engines. This feature should only be programmed by the
installer, and the operation of this feature depends on the correct connection of the
neutral safety wire to the vehicle’s parking brake. Please refer to the “Black/White
wire” in the installation manual for the proper connection of this important wire.
Feature #13 Data Port Protocol
D2D (Trilogix)
(press the brake pedal 1 time to program)
- DeFauLT
aDS (iData)
(press the brake pedal 2 times to program)
This feature determines which data protocol is used on the data ports. Choose this
based on the interface module being used.
NOTe: OmegaLink modules support
both protocols. The aDS protocol is recommended for maximum capabilities.
Feature #9 Lock/unlock Outputs
0.8 Second Output
(press the brake pedal 1 time to program)
- DeFauLT
3 Second Output
(press the brake pedal 2 times to program)
Double 0.8 Sec unlock
(press the brake pedal 3 times to program)
This single feature gives the installer several needed options, to match the system’s
doorlocking outputs to suit different vehicle requirements.
Feature #8 Low Temp Crank extender
0ms (Off)
(press the brake pedal 1 time to program)
200ms
(press the brake pedal 2 times to program)
- DeFauLT
300ms
(press the brake pedal 3 times to program)
400ms
(press the brake pedal 4 times to program)
When the vehicle’s interior temperature is below freezing, this feature adds extra
crank time to the base timing (see installer feature #7). It applies to “Tachless” &
“Crank Only” modes only (installer feature #3)
Feature #10 remote Start Lock Control
Off
(press the brake pedal 1 time to program)
- DeFauLT
Lock after Start
(press the brake pedal 2 times to program)
unlock before start
(press the brake pedal 3 times to program)
unlock Lock after Start
(press the brake pedal 4 times to program)
This feature allows for OEM alarm/lock control in relation to remote start operations
thus eliminating extra wiring.
