18
OPTIC EXCALIBUR
English
200
210
200
210
200
210
•
Unscrew the knob
(
M1
) by 1/2 a turn and release the pressure
in the pistol in two bursts;
•
Check that the reading on the pressure gauge is correct
(200
– 210 bar)
;
•
Tighten the ring nut
(
M5
) well, using a 30 mm spanner.
•
Complete the operating procedure as described in paragraph
“
G
” of this manual;
•
Wait for the machine to reach maximum pressure and stop.
Use the pistol to spray a few bursts into the paint container
and then check the reading on the pressure gauge;
YES
If the reading on the pressure is not as indicated, proceed as
follows:
Value lower than 200 bar
NO
NO
•
Loosen the ring nut
(
M5
) by 1/2 a turn and tighten the knob
(
M1
) all the way;
•
Check the pressure again as described in the previous points,
and repeat the process until the correct pressure reading is
obtained
(200 – 210 bar)
;
•
Tighten the ring nut
(
M5
) well, using a 30 mm spanner;
Value higher than 210 bar
The pressure gauge reading must be 200 - 210
bar max.
Pressures exceeding 210 bar compromise the
correct functioning of the machine and are of no
use as the safety valve is set to release pressures
exceeding 210 bar.
Reference mark
Reference mark
M5
M1
M12
M13
Summary of Contents for Larius
Page 2: ......
