12
using The Valet Switch (cont’d)
REmOTE START VALET mODE
, while active, disables remote start� Keyless entry
and alarm functions are still operable� To enter remote start valet mode, perform the
following steps:
STEP 1 -
Disarm the system either with the controller or by performing an emergency
override and hold the brake pedal�
STEP 2 -
Press and hold the valet switch (located in the window-mount antenna) for
2 seconds� The system will chirp once and the gREEN status light will turn on� The
controller will not reflect remote start valet mode.
FuLL VALET mODE
combines both alarm & remote start valet modes� To acti-
vated full valet mode, follow these steps:
STEP 1 -
Enter remote start valet� You will hear a chirp�
STEP 2 -
Release the brake pedal but continue holding the valet switch� After 2 sec-
onds, you will hear a second chirp�
STEP 3 -
Immediately release the valet switch� The status light will alternate between
RED and gREEN every second�
EXITInG VALET mODES
is as simple as just pressing and releasing the valet
switch once� The status light will turn off� This procedure is the same for all forms of
valet mode�
SECuRECODE
SecureCode allows you to customize the number of valet presses required to per
-
form an emergency override� This is an extra layer of security that prevents anyone
from overriding the alarm even if they have a key to the vehicle� SecureCode has 2
stages with the first requiring 1-9 button valet presses and the second requiring 0-9
valet button presses� This gives you 99 possible combinations� To program a custom
SecureCode, please refer to user feature #1� To perform an emergency override with
SecureCode, use the following steps:
STEP 1 -
With the system armed, enter the vehicle (the alarm will trigger)�
STEP 2 -
Turn the ignition switch to the “ON” position�
STEP 3 -
Within 5 seconds of step 2, press the valet switch to enter the first digit of
your programmed code�
STEP 4 -
After a few seconds, the siren will stop sounding and chirp once (confirming
stage 1)� The siren will then continue sounding�
STEP 5 -
Now, within 5 seconds of step 4, press the valet switch to enter the second
digit of your code� If the code is correct, the alarm will disarm�
If the code is entered incorrectly, you must turn the ignition key OFF, then back
ON to try again�
Additionally, if 2 failed attempts are made, the alarm will ignore any
further attempts for 2 minutes�
The Status Light
The status lights, located in the window-mount antenna, provide a visual indication
of the system’s status via gREEN (remote start status) and RED (alarm status) lights�
SECuRITy SySTEm STATuS (RED LIGHT):
OFF:
The alarm is disarmed and not performing any automatic functions�
On COnSTAnT:
The alarm is in valet mode�
FLASHInG SLOW:
The alarm is armed and monitoring all entry points�
FLASHInG FAST:
One of the automatic arming features is in progress�
