15
If the Unauthorized Transmitter Alert feature is on, programming a transmitter to the
system will activate the “UTA” warning and the extended Status Light indication For
the next 48 hours, the siren/horn will sound a brief series of chirps every time the
vehicle’s ignition key is turned on
Special Programming procedure to turn on the UTA feature:
Using this method
to program transmitters or optional controllers, and to turn on the Unauthorized Trans
-
mitter Alert feature.
Follow the same steps as the Standard Programming, but on any transmitter/con-
troller being programmed instead of pressing the “
lock
” button, press the “
lock
” and
the “
unlock
” buttons together This action turns
on
the Unauthorized Transmitter
Alert feature and at the same time programs the transmitter or controller to operate
the system
Once the Unauthorized Transmitter Alert feature is turned on, the warning will
sound for 48 hours after any transmitter programming, including the programming
session which was used to turn it on. This feature can only be turned off again by
sending the system back to Omega for a reset.
Step 1
Turn the ignition key “On”, then “OFF”
Step 2
Within 5 seconds of step 1, press the valet switch 5 times to access user
features (10 times to access installer features).
~ The siren/horn will sound and the status light will turn on
Step 3
Within 10 seconds of step 2, press the valet switch the number of times cor
-
responding with the desired feature’s number.
~ The siren/horn will chirp, the status lights, and the parking lights will flash equal
to the selected feature.
Step 4
Change the feature by pressing the transmitter button that corresponds with
the desired setting The siren/horn will chirp to correspond with the chosen setting
Programming Features
Standard Programming:
Using this method to program additional or replace-
ment transmitters does not turn on or otherwise affect the Unauthorized Transmitter
Alert (UTA) feature. Before you begin, have all transmitters which are to operate the
system at hand and make sure the correct vehicle profile (see page 12) is selected on
the controller(s)
Step 1
Then, turn the ignition “on”
Step 2
Within 5 seconds of Step 1, press the Valet Switch 5 times. The siren/horn will
briefly sound, confirming that the system is ready to learn a transmitter code.
Step 3
Press the “
lock
” button on each transmitter one at a time The system will
chirp the siren/horn once to confirm that each was learned. If a code is not received
within 10 seconds of Step 2, the learning process will automatically exit.
Programming Controllers/Transmitters
