Excalibur AL-1660-EDPB, Operation Manual

Page: 14 / 20

user Programmable Features (cont’d)
Feature #15 - Alarm Trigger Duration
30 Seconds (press “ lock ” button to program) - DEFAuLT
60 Seconds (press “ unlock ” button to program)
90 Seconds (press “ trunk ” button to program)
120 Seconds
(press “
start
” button to program)
This feature selects the period of time for which the system sounds the siren (and/or
horn) and flashes the lights when triggered. Caution: Before lengthening the Alarm
Duration you should always check and determine if there are any local anti-
noise or nuisance ordinances in your area.
Feature #16 - Arming Delay
3 Seconds (press “ lock ” button to program) - DEFAuLT
15 Seconds
(press “
unlock
” button to program)
30 Seconds
(press “
trunk
” button to program)
45 Seconds (press “ start ” button to program)
This selects how long the alarm waits to monitor trigger zones after arming�
Feature #17 - Open Door Warning upon Arming
On (press “ lock ” button to program)
Off (press “ unlock ” button to program) - DEFAuLT
When this feature is turned on, if one of the vehicle’s doors is open at the time that
the system is armed via the controller or transmitter, the siren will chirp 3 times and
the parking lights will flash 3 times instead of once.
Feature #14 - ignition Activated Override
On (press “ lock ” button to program)
Off (press “ unlock ” button to program) - DEFAuLT
This feature allows an activated system to be overridden and disarmed by simply
turning the ignition switch on within 10 seconds of the system’s activation� After 10
seconds, the Emergency Override must be performed�
Feature #13 - SecureCode
DEFAuLT - 1 Press
SecureCode is a unique patented feature which allows you to custom select the
number of Valet Switch presses in two stages, instead of a single “1 press”, which
would be required in order to perform an Emergency Override. If any of the three anti-
carjacking features are utilized, a customized SecureCode would also be required to
turn it off once it is fully activated� SecureCode operation is described on page 9�
To custom program a new SecureCode:
Step 1 Access user feature #13 (follow the steps on page 9)�
Step 2 Within 10 seconds slowly press and release the transmitter’s “ arm/lock ”
button the number of times equal to the desired SecureCode for stage 1, allow the
system to respond to each transmitter button press with a siren chirp before pressing
the button again. A few seconds after the final button press, the system will chirp the
horn/siren confirming the total number for stage 1.
Step 3 Configure stage 2 of the SecureCode by pressing and releasing the “ disarm/
unlock ” button the number of times desired for the stage 2� The system will
confirm as it did for stage 1.
14