To control the DELAY or ACCUM scope:
1. Slide the
PAUSE/PLAY
switch to
PAUSE
2. Press
SELECT
until you see the words DELAY (or ACCUM) and ALL in the
display.
3. Use the
+
button to
SELECT
On
or
OFF
.
SELECT
On
to apply the count-down delay (or bonus time) to any primary and
secondary time controls you’ve set in addition to sudden-death.
SELECT
OFF
to apply the count-down delay (or bonus time) to sudden-death only.
4. Press
VERIFY
or slide the
PLAY/PAUSE
switch to
PLAY
.
Enabling WORD mode for “Negative” count-up time
For Word games time never runs out, so when the main time has counted down to zero,
the clock enters overtime. In overtime the time is counted up instead of down. When in
WORD
mode, the GameTime™ shows the overtime condition by turning on the appro-
priate players
FLAG
. Some digital clocks that do not have a
FLAG
symbol, place a
minus sign in front of the time to indicate it is displaying overtime time.
NOTE:
While in
WORD
mode, the
DELAY
feature is not available.
To activate the Word mode feature:
1. Slide the
PAUSE/PLAY
switch to
PAUSE
.
2. Press the
SELECT
button until you see the word
WORD
on the display.
3. Use the
+
button to select
On
.
4. Press
VERIFY
or slide the
PAUSE/PLAY
switch to
PLAY
.
Controlling the display of Seconds for time over 10 minutes
GameTime™ normally always shows the remaining seconds. For times less than 10
minutes, the remaining seconds are shown to the right of the colon (
:
) symbol. For time
greater than 10 minutes the remaining seconds are shown in two smaller digits next to
the three large minutes digits. If you prefer to only see the large three minutes digits,
you may turn off the display of remaining seconds on the small digits.
To control the small digit display of remaining seconds feature:
19
Summary of Contents for 750GT-2
Page 1: ...GameTime II INSTRUCTION GUIDE Model 750GT 2 ...
Page 26: ...26 NOTES ...
Page 27: ...27 APPENDIX A ...
