Operation
English
13
Exact Bevel Pro Series pipe cutting system operation instructions
Cut+Bevel Pro Series features
Bevel depth and width is adjusted with depth
adjustment roller (Fig. B). Turning the roller
clockwise will make deeper and wider bevel and
turning the roller counterclockwise will make smaller
and thinner bevel.
Please note that the adjustment is effective only
when motor unit is locked in down position. This
adjustment is recommended to do before starting
the cutting.
When using the machine on a new pipe size, adjust
the cutting depth higher than needed prior to cutting.
It is easier to make the cut deeper than lower by
adjusting the depth adjustment roller when motor
unit is in locked down position. Correct depth setting
is confirmed with visual evaluation of the cutting
result.
Bevel Pro Series machine locks to the
same depth setting if depth adjustment roller is not
moved. Therefore Cut+Bevel cuts can be made on
same size pipes without any additional adjustment.
Beveling forces will push the saw to the right. To
compensate these and achieve a straight cut, motor
unit needs to be turned left. Size of this adjustment
depends on pipe material, wall thickness and bevel
size, one good adjustment position cannot be given.
To make the adjustment:
- Loosen the two screws on the body plate
- Turn bodyplate counterclockwise
- Tighten the screws
Changing the lower blade guard
When using the Cut+Bevel Diamond disc, be sure to
use also the lower blade guard with wider opening
on the bottom. Regular lower blade guard does not
have work with Cut+Bevel Diamond disc.
Lower blade guard is changed as follows:
- Remove blade and blade flanges from the
saw if
fitted.
- Remove the retaining ring from the axle
(right and Fig A2).
- Pull the lower blade guard, washer, spring
and bushings of the axle. Note the locations
of bushings and spring.
- Insert bushings to the lower blade guard to
be installed
- Insert the lower blade guard with bushings,
washer and spring on the axle. Be sure to
locate the spring correctly.
- Test the correct function of the lower blade
guard, it will return to low position when
released and that it can move without any
restriction.
Before operation the tool
- For Cut+Bevel function, ensure that Cut+Bevel
Diamond disc is installed to the saw.
