Operation
English
18
Cutting result adjustment for models Exact Bevel 280 / 360 / 460 Pro Series
Within the gripping devices of these models there are
eight control wheels. One of them is the adjustment
wheel (FIGURE A / 9). Please note that adjustment by
this wheel concerns only the size of one pipe and
material and the wheel may need to be adjusted again
as the saw blade or disc wears out.
Adjust the wheel by releasing the locking screw
(FIGURE L / 1) and turning the central part of the wheel
CLOCKWISE or ANTICLOCKWISE to obtain the
desired position (FIGURE L / 2), lock the wheel again
(FIGURE L/3).
If the saw is moving from right to left (FIGURE K/a),
turn the central part of the adjustment wheel so that "d"
is smaller (FIGURE K/a). If the cutting is carried out
according to Figure K/b, proceed as shown in Fig. K/b.
It is recommended to lubricate the adjusting wheel
periodically.
In these models the angle of the entire engine can be
adjusted left or right. The laser beam can be used to
aid in correct adjustment.
Adjustment stages
1. Mark the reference line precisely on the pipe at an
angle of 90 degrees in the longitudinal direction.
2. Place the saw on the pipe so that the red line of the
laser is next to the reference line at an angle of 90
degrees. Tighten the griper to the normal tension level.
Check if the laser line and reference line are parallel. In
FIGURE M/A the laser beam is not parallel with the
reference line.
3. Release the two locking screws of the adjustment
plate (FIGURE M/b 1 and 2).
4. Adjust the motor unit to the left or right as needed to
get the laser beam and the reference line parallel. In
FIGURE M/c the laser beam is parallel with the
reference line.
5. Tighten the locking screws of the adjustment plate
very tightly.
CAUTION
!
The adjustment indicator located in the back
of the adjustment plate does give the exact
measurement to adjust. The indicator shows only the
direction of adjustment and the category of magnitude.
FIGURE
L
FIGURE
M /a
FIGURE
M /b
FIGURE
M /c
Rotate wheel to
make
d bigger
Rotate wheel to
make
d smaller
