H
How does the Cylinder warranty work?
1) Coverage
Your cylinder is covered for
Ϯ
years from the year that is stamped on the cylinder.
2) How to test if your cylinder is defective or not?
1) Prepare a bucket of hot water and a bucket of cold water.
2) Put the cylinder in the bucket of cold water for around 10 minutes and then push the piston pin in
as far as it will go.
3) Then put the cylinder in the bucket of warm water. Observe if the piston pin comes out (it can take
around 10 minutes before something will happen). If the piston pin doesn’t come out by
approximately 8 cm then it means that the cylinder is defective and you can take advantage of your
warranty.
3) Leaking cylinder?
Is covered during the warranty period.
4) Cracked cylinder
ŽƌƌƵďďĞƌƉůƵŐĐŽŵŝŶŐŽƵƚƚŚĞĞŶĚ
?
An overloaded cylinder as a result of
ŝŶĐŽƌƌĞĐƚŝŶƐƚĂůůƚŝŽŶͬƵƐĂŐĞŽĨĂƵƚŽ
ŽƉĞŶĞƌ
is normally not covered by the warranty. Individual treatment each
time. See example to the right.
dŚĞ
cylinder can be overloaded due to incorrect installation. See our
installation videos on
www.orbesenteknik.com
for the correct installation
procedure.
5) Should you send the damaged cylinder back to us?
No, we only need you to send us a picture,
of the cylinder where we can see the mark
“ORBESEN TEKNIK and YEAR” on the
cylinder, along with the damage and an
explanation of occurred. Please include
your address so that in a case of warranty
coverage we can send a new cylinder.
^ĞŶĚƚŽŚĞůƉĚĞƐŬΛĞdžĂĐŽ͘ĐŽŵ
Piston pin
Mark ORBESEN TEKNIK & Year
30
