FR
DE
IT
UK
NL
PL
PL
7
Press the button to set the timer and programme when
the appliance should stop functioning. The timer can be set
When the timer is activated, the indicator light will switch
To stop the timer, press until the timer indicator reaches
allows you to switch oscillation of the appliance on
or off. When oscillation is switched on, the will be lit up on
This mode allows the appliance’s speaker to be connected
to a smartphone or a tablet via wireless connection, allowing
Select the name of the appliance “EWT RB2M” on your
Once the connection has been established, start and control
Appliance On/Off
Control of heating and
Wireless connection
When inserting or removing the battery, please consult
the diagram below. Pay attention to the guide on the lid
explaining the positioning of the positive and negative
Remove the protective cover from the battery slot of your
Avoid dropping the remote control or allowing it to fall to
Batteries contain materials that are dangerous for the
environment. When disposing of the appliance, the
batteries must be removed from the remote control and
disposed of in an appropriate place - Please refer to
recycling section.
CLEANING AND MAINTENANCE
Switch off the appliance first and disconnect the plug from
the socket.
• Clean the housing with a moist cloth, vacuum cleaner or
brush.
• Do not use any abrasive or caustic cleaning agents.
• Do not use any flammable cleaning agents e.g. petrol or
spirit for cleaning the appliance.
• Never immerse the appliance in water.
• Air inlet and outlet area should be cleaned with a vacuum
cleaner regularly·
• If the appliance is not used for extended periods, it must
be protected against excessive dust and dirt.
RECYCLING
For electrical products sold within the European
Community. At the end of the electrical products
useful life it should not be disposed of with
household waste. Please recycle where facilities
exist. Check with your Local Authority or retailer for recycling
advice in your country.
Batteries should be disposed of or recycled in accordance
with WEEE Directive 2012/19/ EU. Packaging should be
recycled where possible.
AFTER SALES SERVICE
Should you require after sales service please contact the
retailer from whom the appliance was purchased or contact
the service number relevant to your country on the warranty
card.
Please do not return a faulty product to us in the first
instance as this may result in loss or damage and delay in
providing you with a satisfactory service.
In the interests of further development, the appliance may
be subject to constructional or design changes without prior
notice.
Please retain your receipt as proof of purchase.
INFORMATION REQUIREMENTS APPLYING TO PORTABLE
ELECTRICAL HEATING DEVICES
MODEL IDENTIFIER
RB2M
Heat output
Nominal heat output
Pnom
2.2
kW
Minimum heat output
(indicative)
Pmin
0
kW
Maximum continuous heat
output
Pmax,c
2.2
kW
Auxiliary electricity Consumption
At nominal heat output
elmax
N/A
kW
At minimum heat output
elmin
N/A
kW
In standby mode
elSB
0.002
kW
Type of heat output / room temperature control
Electronic room temperature control
Yes
RB2M.indd 7
11/06/19//24 13:57
