INSTALLATION INSTRUCTIONS
PRE-INSTALLATION INSTRUCTIONS
Contact your local distributor to have a complete water analysis and check your water hardness
on your water supplier, this will keep your conditioner in proper working.
YOU MUST FOLLOW ALL GOVERNMENT CODES AND REGULATIONS GOVERNING THE
INSTALLATION OF THESE DEVICES.
Fig.1
Electrical Panel
Cold Soft Water
Hot Soft Water
Water Heater
Filter&Softener
Drain
Water Meter
Raw Water
To Outdoors
Hard
Filtered
Water
Ground Strap
DETERMINE THE CORRECT LOCATION OF THE WATER CONDITIONING EQUIPMENT
Select the location of your softener with care. Review the various conditions below to
determine a proper location:
1.
Locate as close as possible to the water supply source.
2.
Locate as close as possible to a oor or laundry tub drain.
3.
Locate in correct relationship to other water conditioning equipment (See Fig. 1).
4.
Softener should be located in the supply line before the water heater. Temperatures above
48.8
℃
(120°F) damage softeners.
5.
Do not install a softener in a location where freezing temperatures occur. Freezing may
cause permanent damage to this type of equipment and will void the factory warranty.
6.
Allow suffi
cient space around the unit for easy servicing.
7.
Determine if additional plumbing is required if your water source is a community water
supply, a public water supply or you wish to bypass water used for a geothermal heat pump,
lawn sprinkling, out-buildings or other high demand applications, refer to Fig. 1
）
.
8.
Keep the softener out of direct sunlight. Heat build up from direct sunlight may soften and
distort plastic parts.
