READ THIS PAGE FIRST
BEFORE STARTING INSTALLATION
Personal injury or property damage could result if you fail to
follow instructions in this manual.
It is recommended to annually inspect and service the
control valve. Frequent cleaning and/or replacement
of piston, seals, and/or spacers may be necessary
depending on how harsh the conditions are.
This system and its installation must comply with state
and local regulations. Check with your local public works
department for plumbing and sanitation codes. Local codes
should be followed in the event the codes con ict with any
content in this manual.
This water Softener must be operated on pressures
between 0.2MPa(30 psi) to 0.86MPa(125 psi). If the water
pressure is higher than 0.86MPa(125 psi), use a pressure
reducing valve in the water supply line to the softener.
This unit must be operated at temperatures between 4°C -
43°C
（
40°F and 110°F)
Do not use this water softener on hot water supplies.
Do not install this unit where it may be exposed to wet
weather, direct sunlight, or temperatures outside of the
range speci ed above.
This appliance can be used by children aged from 8
years and above and persons with reduced physical,
sensory or mental capabilities or lack of experience
and knowledge if they have been given supervision or
instruction concerning use of the appliance in a safe way
and understand the hazards involved.
You must read and understand the contents of this manual
before installing or operating your water softener.
So ftene rs are expo se d to hig h level s o f iron,
manganese, sulfur, and sediments. Damage to pistons,
seals, and/or spacers within the control valve are not
covered in this warranty due to the harsh environment
.
Do not use water that is microbiologically unsafe
without adequate disinfection before or after this
system.
This publication is based on information available when
approved for printing. Continuing design refinement
could cause changes that may not be included in this
publication.
Apply provided NSF certified lubricant to all o-rings
during installation. Do not use pinched or damaged
o-rings during installation.
The appliance is only to be used with the power supply
unit provided with the appliance.
The appliance must only be supplied at safety extra low
voltage corresponding to the marking on the appliance.
Children shall not play with the appliance.
Cleaning and user maintenance shall not be made by
children without supervision.
INSTALL
NOTES &
SAFETY
MESSAGES
Watch for the
following messages
in this manual:
CAUTION
EXAMPLE:
Disassembly while under pressure
WARNING
Electrical Shock Hazard! Unplug the unit before removing
the cover or accessing any internal control parts.
EXAMPLE:
EXAMPLE:
Check and comply with
your state and local
codes. You must follow
these guidelines.
NOTE
