EWT CS 4 COMFORT, Operator'S Manual

Page: 39 / 120

39
WET – VACUUM OPERATION
4
2 5
6
1
3
BEFORE YOU START
WARNING!
You must first read and understand the section on
“precautions and guidelines regarding safety” and take them
into account.
1. Make sure the appliance is not plugged into the mains. Check that the container is clean and dust free
(Fig. 1).
2. Remove the dust bag and the cartridge filter. Leave only the foam filter on the filter housing. Replace
the upper part of the container and close the container clasps (Fig. 2).
DO NOT USE a cartridge filter for vacuuming liquids
3. Insert the largest end of the hosepipe into the suction port on the front of the container and lock it by
turning it to the right. Select the desired nozzle or the extension(s) and fit them onto the hosepipe
(Fig. 3).
4. Make sure the Stop/Start switch on the appliance is in the “Stop” position (“O” position) before plugging
into the mains (Fig. 4).
5. Start the motor (Start/Stop switch in the “Start” position (“I” position) (Fig. 5).When you have finished
vacuuming, stop the motor by putting the Start/Stop switch in the “Stop” position (“O” position).
Unplug from the mains.
6. After use, empty the container and dry it.
IMPORTANT! If you wish to vacuum large quantities of liquid from a sink, a tank or similar, do not place
the whole of the nozzle in the liquid, but leave a little room so that are can be vacuumed along with the
liquid. The appliance is fitted with a float switch which blocks vacuuming when the container is full. You
can tell when vacuuming stops because the motor turns faster. If this happens, stop the appliance
immediately and disconnect from the mains. Take into account that a full container can be very heavy.