ES 2050/51
Status and regeneration messages
4
However some operating regimes will produce alternative messages :-
Either:
When operating with the control set to prohibit regeneration between certain times (section 3 of the
programming instructions), if regeneration is required it will be postponed and the initiation signal
stored until the end of the prohibited period, the second line of the display will show the time at
which the unit will commence regeneration and the current time.
or:
If the control has been set to initiate a regeneration after a fixed time interval the second line of the
display will show the number of hours remaining until regeneration will take place and the current
time.
or:
The control can be programmed to give a signal, e.g. for a bleed valve, each time a predetermined
volume of water has been supplied. When this output is active the second line of the display shows
the remaining signal duration.
Regeneration status.
The first line of the LCD display indicates the actual condition of the plant, e.g. unit 1 in regeneration.
The second line of the LCD display shows, the regeneration step or phase in progress, the time
remaining in the step and indicates, when an additional routine has been selected (section 15 of the
programming instructions), whether the output is active. "-" indicates active "l" indicates inactive. If
"Step: 0" is displayed it means that the additional routine will operate before regeneration can
commence, similarly "Step: 6" indicates that the additional routine is continuing beyond the end of the
regeneration cycle. If required the duration and remainder of the additional routine can be displayed
briefly by pressing the INFO key (see page 6).
Service unit 1
Reg18:00 17:00
Service unit 1
Reg 72h 17:00
Service unit 1
Flush-time 20s
Regen. unit 1
Phase : 2 15 Min.-