Design and function
Interfaces for automation
62
099-000229-EW501
14.04.2015
5.9.6.1 Ramp function foot-operated remote control RTF 1 / RTF 2
ENTER
+
EXIT
NAVIGATION
l
0
Figure 5-33
Display
Setting/selection
Exit the menu
Exit
Machine configuration (part two)
Settings for machine functions and parameter display
Ramp function Remote control RTF 1
The ramp function can be switched on and off
Switch on
Switching on machine function
Switch off
Switching off machine function
5.9.7
Power-saving mode (Standby)
The power-saving function can be activated either by pressing the button for a longer time - See 4.3
Machine control
– Operating elements chapter or by setting a parameter in the configuration menu (time-
based power-saving mode).
When power-saving mode is activated, both machine displays show the horizontal digit in the
centre of the display only.
Pressing any operating element (e.g. tapping the torch trigger) deactivates power-saving mode and the
machine is ready for welding again.
5.10 Interfaces for automation
CAUTION
Damage to the machine due to improper connection!
Unsuitable control leads or incorrect connection of input and output signals can cause
damage to the machine.
• Only use shielded control leads!
• If the machine is to be operated with control voltages connection via suitable isolation
amplifiers is required!
• To control the main or secondary current via control voltages, the relevant inputs must be
enabled (see specification for activation of control voltage).
