Functional characteristics
TIG welding
099-00T401-EW501
01.02.2022
47
Display
Setting/selection
Parameter activArc
> see 5.1.5 chapter
Setting the intensity
Filler wire process (cold/hot wire)
------
filler wire activated
------
filler wire deactivated (factory setting)
Hot wire process (start signal for hot wire power source)
-------Function enabled
-------Function disabled (ex works)
Wire/pulse function (wire feeding behaviour when using pulsed TIG welding)
Wire feeding can be disabled during pulse pauses (not the case for automated pul-
sing or kHz pulsing).
-------Function disabled
-------Function enabled (ex works)
Filler wire diameter (manual setting)
Setting the wire diameter between 0.6 mm to 1.6 mm.
The character "d" preceding the wire diameter on the display (d0.8) indicates a pre-
programmed characteristics (correction operating mode "KORREKTUR”).
If there is no characteristics for the selected wire diameter, the parameters have to be set
manually (manual operating mode “MANUELL“).
Wire return
• Increase value = more wire return
• Decrease value = less wire return
Ignition type (TIG)
-------HF start active (ex works)
-------Lift arc ignition active
