7
Short Operating Manual SATURN M201 PROGRAM
7/1
Setting the welding task
(One-knob operation programme)
entsprechend der Schweißaufgabe:
Gas type
Set type of gas
Wire diameter/
Material type
Set switch to type of material with the
corresponding wire diameter
Welding power in fine steps
Setting the welding power in fine steps
Operating mode selection switch
2 stroke setting
4 stroke setting
Spot
welding
Setting the operating mode
Signal lamp lights:
Welding power too high
Switch the selection switch lower
Signal lamp lights:
Welding power too low
Switch the selection switch higher
0
m/min
2
4
6
8
-10
2
4
6
8
+10
15
20
1
5
10
The optimum wire feed speed is
automatically pre-set on pressing the torch
trigger
This can be corrected with the potentiometer
Setting the wire feed speed correction
(outside scale)
Setting the welding parameters (Two knob operation manual)
Welding wire diameter/
Type of material
Set the selector switch to „manual“
two knob operation
Welding voltage in fine steps
Setting the welding voltage in fine
steps
Setting the wire feed speed
Setting the wire feed speed
(Welding voltage)
1-20 m/min(inner scale)
Summary of Contents for SATURN MIG 200
