Functional characteristics
MIG/MAG welding
Item No.: 099-005073-EWM01
27
5.2.3.4
Wire burn-back
Operating
element
Action Result
Display
3 sec.
Selects wire burn-back
m/min
Parameter setting
(setting range 0 to 499)
5.2.3.5
Accessory components for operating point setting
Accessory component
Description
PHOENIX R10 remote control
See "Remote controls" chapter
PHOENIX R20 remote control
See "Remote controls" chapter
PHOENIX R40 remote control
See Phoenix R40 operating instructions
MIG/MAG Powercontrol program torch
See "MIG/MAG Powercontrol program torch"
chapter
MIG/MAG Powercontrol2 torch
See Powercontrol2 torch operating instructions
PC300.Net PC software
See PC300.Net operating instructions
RINT X11 robot interface,
industrial bus interface
See RINTX11 operating instructions
5.2.4
MIG/MAG welding data display
To the left of the LCD display on the control there is an “arrow button” (
) for selecting the welding
parameters to be displayed. This button is used to scroll through the parameters from top to bottom.
When the last point is reached, the next parameter shown will be the top one.
The settings for the gas post-flow time, wire burn-back and hotstart current are also made in this way.
Figure 5-4
The parameters can be displayed before (nominal values), during (actual values) or after welding (hold
values; the "Hold" signal light will be on).
Parameter Before
welding
(nominal values)
During welding
(actual values)
After welding (hold
values)
Welding current
z
z
z
Material thickness
z
Wire speed
z
z
z
Welding voltage
z
z
z
As soon as changes have been made to the settings (e.g. wire speed) after welding when the hold
values are displayed, the display will be switched to the nominal values.
