Product description – quick reference
Function torch
099-500050-EW501
04.08.2016
19
4.3.7
Welding data display
The signal lamps in the lower part of the torch display indicate the welding parameters currently selected.
The corresponding parameter value is shown on the three-digit display.
After the welding machine is switched on, the active JOB number is shown on the display for approx. 3
seconds. The display then switches to the setpoint value for the welding current or wire speed.
In up/down mode, the corresponding parameter value is shown on the display for parameter changes. If
this parameter is not changed for approx. 5 seconds, the display switches back to the values specified by
the machine control.
V
A
JOB
4
3
2
1
5
Figure 4-9
Item Symbol Description
0
1
Three-figure display
Display of welding parameters
> see 4.3.7 chapter
.
2
A
Welding current display signal lamp
3
Wire speed display signal lamp
4
V
Voltage correction display signal lamp
5
JOB
JOB number display signal lamp
Example displays for welding parameters in the welding data display
Welding parameters
Display
Welding current
Wire speed
Voltage correction
Programs
JOB number
V
A
JOB
V
A
JOB
V
A
JOB
V
A
JOB
V
A
JOB
