CONV Pelco To Bosch - firmware 0.01.xx
Ewimar Sp. z o.o.
www.ewimar.pl
Made in Poland
26
Call preset 123
Single Playback Pattern B (ON-53-ENTER)
27
Call preset 124
Clear Alarm (OFF-65-ENTER)
28
Call preset 125
Start Autotracking (ON-78-ENTER)
29
Call preset 126
Run Tour Custom (ON-7-ENTER)
30
Call preset 127
Run Tour (ON-8-ENTER)
31
Call preset 128
Start other AUX OFF procedure
32
Call preset 1-99
SHOT 1-99
33
Set preset 96
Lock menu (ON-90-ENTER)
34
Set preset 97
Enable OSD (ON-46-ENTER)
35
Set preset 98
Pre-position Title menu (ON-62-ENTER)
36
Set preset 99
Zone Title menu (ON-63-ENTER)
37
Set preset 100
Enters the Pre-position menu (SET-100-ENTER)
38
Set preset 101
Set–programs left limit (SET-101-ENTER)
39
Set preset 102
Set–programs right limit (SET-102-ENTER)
40
Set preset 105
Access the password menu (SET-802-ENTER)
41
Set preset 106
Display current address (ON-997-ENTER)
42
Set preset 107
Display and program current address (ON-998-ENTER)
43
Set preset 108
Display and program unaddressed (ON-999-ENTER)
44
Set preset 109
Inactivity mode(ON-9-ENTER)
45
Set preset 110
Go to home position (SET-110-ENTER)
46
Set preset 111
Record pattern A (ON-100-ETER)
47
Set preset 112
Record pattern A (ON-101-ETER)
48
Set preset 113
Tour edit 1 (ON-900-ETER)
49
Set preset 114
Auto Pan/Scan 1 (ON-14-ENTER)
plus
50
Set preset 115
Tour Speed 1 (ON-15-ENTER)
plus
51
Set preset 128
Start other AUX ON procedure
32
Set preset 1-99
SET SHOT 1-99
Activation of any AUX ON / AUX OFF number
Bosch cameras support 1023 AUX commands, which are intended for performing special functions,
among others for remote address setting (Fast-address).
Because the Pelco protocol does not allow for the transmission of such information, the converter has a
special procedure for activating the AUX function using a combination of Set Preset / Call Preset
commands. The rules and examples of sending AUX commands are described below.
Moving the joystick between individual steps or performing other operations cancels the AUX procedure.
Entering values outside the range also cancels the AUX procedure.
NOTICE! The described procedure only works correctly with keyboards that send preset commands only
once at start-up. Some keyboards may send a PRESET command twice, in which case the AUX function
cannot be used.
SEND AUX ON 1~99
[SET PRESET 128] + [SET PRESET 1~99] + [SET PRESET 128]
Start procedure Value Enter
SEND AUX ON 101 – 1023
[SET PRESET 128] + [SET PRESET 1~10] + [SET PRESET 1~99]
Start procedure Value * 100 Value *1
