17
6.0 In s ta llation an d fir st o p eration
6.0 Installation and first operation
Authorized personnel
• The installation and first start of operation may only be
conducted by qualified personnel.
• Work on the electric system may only be performed by
trained electricians.
WARNING
Electric shock and moving parts hazards
Serious injury or death can be caused by touching live electrical
components and by unexpected movement of the actuator.
Be sure the system’s power supply is off and actuator is locked
out before installing.
WARNING
Danger if restarted without authorization!
When correcting faults, there is danger of the energy supply being
switched on without authorization. This poses a lifethreatening
hazard for persons in the danger zone.
Therefore:
• Prior to starting work, switch off the system and safeguard
it from being switched on again.
WARNING
Risk of injury and material damage due to incorrect installation
of the optional devices!
Therefore:
• Optional devices, in particular components that are part of
a retrofitting, may only be installed in accordance with the re-
spective instructions (circuit diagram).
• The electromagnetic compatibility must be tested for the routing
and appropriate measures must be carried out if necessary.
6.1 Installation location
Adhere to the technical data in accordance with operating
conditions (⮑ 11 Appendix, page 27).
Install in a location where the actuator is not exposed to
strong UV radiation or corrosive or explosive air media.
6.2 Installation
The CAHB-2… linear actuator is attached to two elements
via the hinge heads.
1. Connect the hinge heads (1
and
2,
⮑
Fig. 12
) to the ap-
propriate elements of the application with the fastening
bolts.
Fig. 12
1
2
NOTE
Information concerning the diameter of hinge heads can be found
in the datasheet. The dimensions of application elements and pins /
fastening bolts should be appropriate. The fit dimensions between
holes and pins should follow the general tolerance principle so that
keep a good installation status
WARNING
Risk of injury and material damage due to insufficient
fastening!
Only use fastener and secure them adequately. Do not use full-
thread screw to install, the thread would damage the attachment
hole and increase friction. Never loosen or otherwise manipulate
screws on actuator or options.
Summary of Contents for CAHB-20E
Page 2: ......
