EVS Multicam LSM, Operation Manual

Page: 37 / 242

Mix / Wipe L>R / Wipe R>L / Wipe U>D / Wipe D>U / Cut
Aud.Met. PgmSpd Sort->TC PostRoll
Mix. Sw to IN Search Pref
These options determine the transition effect that will occur between the PGM and PRV
pictures. The mix, wipe and cut are on the same location. Pressing this button will browse
through these effects, showing the active one on the LCD menu. Please refer to Setup
menu to select the duration of the transition effect.
PgmSpd / VarMax
Aud.Met. PgmSpd Sort->TC PostRoll
Mix. Sw to IN Search Pref
Pressing PgmSpd once enables the Program Speed mode and highlights this function on
the LCD. Pressing the key once more enables the VarMax mode and highlights this
function on the LCD. The
PLAY key is flashing red while either of these modes is
enabled.
• Program Speed mode : In this mode, only two speed values are available from the
lever: 0% when the lever is in the lower position, or the speed defined in the
Operational Setup menu (p.9.1 F3) for any other position of the lever.
• VarMax mode : the speed range defined by the lever is limited between 0% and the
speed value defined in the Operational Setup menu (p.9.1 F3).
Sw To In
Aud.Met. PgmSpd Sort->TC PostRoll
Mix. Sw to IN Search Pref
When this function is enabled (highlighted), a camera change will cause a jump to the
corresponding IN point if existing. It will switch in Sync if no IN point exists for the current
element, or if
Sw to IN is 'OFF'.
See section "Synchronization Mode (Switch To In)" on page 32 for more information on
this option.
Pref
Aud.Met. PgmSpd Sort->TC PostRoll
Mix. Sw to IN Search Pref
Selecting this function enables the Preference mode.
See section "Preference Mode (PREF)" on page 32 for more inforamtion on this option.
OPERATION MANUAL Multicam LSM 12.05
3. Control Modes 25