174
WT.050.580.000.DE.IM.0714
Installation
MFC
6.
6.3
Commissioning
6.3.1
Commissioning Guide
Commissioning procedure
Once the device is mounted, connect the current.
Then, the sensor measuring modules must be equipped and the
application selected.
Depending on the selected controller function and application, the
sensor measuring modules must be installed at the appropriate
slots (see 4.4 “Applications" on page 71 and 4.5 “Controller
Function" on page 77).
The cable descriptions with the numbers 1–4 must be attached to
the sensor cables according to the selected slot. The cable
descriptions are included with the sensor measuring modules and
ensure that cables will not be confused while calibrating multiple
similar measurements (e.g. 2 pH measurements).
To set applications, refer to 6.3.10 “Setting the applications" on
page 199.
The following table contains the individual commissioning steps in
their correct sequence.
More detailed information is contained in the chapters listed in the
"Chapter and page reference" column.
Completion of each step can be confirmed in the "Compl." column.
Please note
If this installation sequence cannot be complied with, please
contact your contractual partner.
Summary of Contents for WALLACE & TIERNAN MFC
