Evoqua WALLACE & TIERNAN MFC, Instruction Manual

Page: 71 / 268

MFC
Functions
4.
71
4.4 Applications
The configuration of the system is determined by:
• The required measurement and control parameters
• The installed components
• The selection of the suitable application
The MFC provides the option to customise the system to the
various on-site systems using five integrated applications. Factory
setting = application 3.
The connections are determined by selecting the applications 1, 2,
3, 4 or 5. Factory settings are always set for the respective
application. However, these can be customised to the respective
system.
Caution!
The defined application 1, 2, 3, 4 or 5 must be entered the first time
the device is switched on (see 6.3.9 “Switching the device on" on
page 198).
It is then not possible to change this for the defined configuration,
otherwise the incorrect controller outputs are activated.
The five applications 1, 2, 3, 4 and 5 are shown below. The
illustrations show the options for wiring the inputs and outputs. The
respective strips are also shown.