23
www.evolutionpowertools.com
NOTE:
The arbor screw has a LH thread. Turn
clockwise to loosen. Turn counterclockwise to tighten.
•
Install the new ø210 mm blade. Make sure the
rotation arrow on the blade matches the clockwise
rotation arrow on the upper guard.
NOTE:
The blade teeth should always point downward
at the front of the saw.
•
Install the blade flange, washer and arbor screw.
•
Lock the arbor and tighten the arbor screw using
moderate force, but do not overtighten.
•
Replace the guard operating arm and its retaining
pivot screw.
(Fig. 27)
•
ensure the Hex Key is removed and the arbor lock
has released before operating.
•
ensure the blade guard is fully functional before
using the machine.
USE OF OPTIONAL EVOLUTION ACCESSORIES
(not supplied as original equipment – see additional
accessories pp 11)
DUST BAG
a Dust Bag can be fitted to the extraction port at the
rear of the machine. The Dust Bag is for use when
cutting wooden materials only.
•
Slide the Dust Bag over the dust extraction port,
ensuring that the spring clip grips the port holding
the Dust Bag securely in place.
(Fig. 28)
NOTE:
For operational efficiency empty the Dust Bag
when it becomes 2/3 full. Dispose of the contents of
the Dust Bag in an environmentally responsible way. It
may be necessary to wear a dust mask when emptying
the Dust Bag.
NOTE:
a workshop vacuum extraction machine can be
attached to the dust extraction port if required. Follow the
manufacturers instructions if such a machine is fitted.
WARNING:
Do not use the Dust Bag when cutting
metallic materials.
Fig. 27
Fig. 26
Fig. 28