18
www.evolutionpowertools.com
Fence Alignment
The fence must be aligned at 90
0
(square) to a correctly
installed blade The rotary table must be set at ‘0
0
’ miter
angle.
The Fence is fastened to the table with two socket
head Hex screws positioned one at either side of the
fence in elongated slots.
(Fig. 12)
•
ensure that the Cutting Head is in the locked
down position with the latching pin fully engaged
in its socket.
•
Place a Set Square on the table with one short
edge against the Fence and the other short edge
against the Blade (avoiding the TCT tips).
(Fig. 13)
•
If adjustment is necessary, loosen the two Fence
adjustment screws using a Hex Key.
•
Re-position the Fence in its elongated slots until
alignment is achieved.
•
Securely tighten the socket head Hex screws.
Mitre Angle Pointer Adjustment
NOTE:
There are dual miter angle scales cast into the
front of the machines base. a small pointer attached to
the rotary table indicates the angle selected.
If necessary the pointer can be repositioned by
loosening its fastening screw using a #2 Phillips
screwdriver. adjust as necessary, and then securely
tighten the fixing screw.
(Fig. 14)
PREPARING TO MAKE A CUT
DO NOT OVER-REACH
Keep good footing and balance. Stand to one side so that
your face and body are out of line of a possible kickback.
Freehand
cutting is a major cause of accidents and
should not
be attempted.
•
ensure that the workpiece is always firmly resting
against the fence, and where practical is clamped
with the Hold Down Clamp to the table.
•
The saw table should be clean and free from any
sawdust etc. before the workpiece is clamped into
position.
Fig. 13
Fig. 14
Fig. 12