Evolution GEN2800BEU, Manual

Page: 15 / 151

128 www.evolutionpowertools.com
®
2. Preparing the Evo-System Engine
Note:
Refer to the Instruction Manual for the Evolution
Evo-System Engine.
• Check the Fuel Level.
• Check the Oil Level.
• Visually check all fuel lines and electrical connections.
3. Starting the Engine
Note:
Refer to the Instruction Manual for the Evo-System Engine
• Start the engine.
• Allow the engine to reach its normal operational temperature.
4. Connecting Electrical Appliances
Note: For some markets the generator can supply either 230V AC
or 110V AC.
Note: The Evo-System Generator is fitted with an earth terminal.
This terminal can be connected to a suitable ‘ground’ connection,
using appropriate cabling etc., when required.
Consult an electrician, suitably qualified supervisor or the relevant
local authorities for specific advice on any earth connection
that may be required for the application and locality where the
generator is to be used.
• If applicable select the voltage required by setting the selection
switch to 230V or 110V. (Fig. 2)
• Ensure that the appliance cable is undamaged and has the
correct plug fitted.
• Route the cable so that it does not pose a trip, or any other hazard.
• The engine and generator must be at full operational
temperature before any appliance is connected.
• Ensure that the appliance ‘ON/OFF’ switch is in the ‘OFF’
position before connection is attempted.
• Open the required plug outlet and make the connection.
Note: Each outlet socket is protected by an overload protection
device. If the overload protector activates, wait a few minutes and
then press the reset button. (Fig. 3) Check the power rating of the
attached devices.
5. Shutting Down
To shut down and turn off the generator:
• Switch off and disconnect all appliances that are connected to
the generator.
• Turn the engine ignition switch to the ‘OFF’ position. (Fig. 4)
• Turn the fuel tap to the ‘OFF’ position. (Fig. 5)
Fig. 2 (UK Professional
version shown)
Fig. 3 (Euro version shown)
Fig. 4