Evolution FURY62102, Original Instructions Manual

Page: 31 / 132

31
www.evolutionpowertools.com
EN
DE
FR
TR
To check:
• Ensure that the Cutting Head is tilted to the 45˚ position,
against its stop, with the Bevel Pointer indicating 45˚ Bevel
Angle.
• Tighten the Bevel Lock Handle.
• Lower the Cutting Head to its lowest position. The Retractable
Lower Blade Guard will rotate up into the machine.
• Use the Engineers 45˚ Set Square to check the angle of
between the blade and the Rotary Table.
If adjustment is required:
Note:
The Cutting Head will need to be tilted to gain access to
the 45˚ Bevel Stop Adjustment Screw.
• Loosen slightly the 45˚ Bevel Stop Adjustment Screw locknut.
(Fig. 32)
• Use a Hex Key to turn the Bevel Stop Screw clockwise or
counterclockwise as required.
• When exact alignment between the
blade and Rotary Table is achieved, tighten the locknut.
FENCE ADJUSTMENT (Fig. 33a & 33b)
The Fence is fastened to the machines base by two (2) socket
head screws, one on either side. These Screws are located in
elongated holes, which enable the Fence to be repositioned
as required.
The Fence should be set at exactly 90˚ to a correctly
installed blade.
An accurate Engineers Square (not supplied) will be required
to precisely position the Fence.
To reposition the Fence:
• Set the Rotary Table to 0˚ Mitre Angle.
• Set the Cutting Head to 0˚ Bevel Angle.
• Slightly loosen the two (2) Fence socket head screws.
• Lower the Cutting Head to its lowest position.
• Check the alignment of the Fence with the Blade using the
Engineers Square.
• Align the Fence as necessary and then tighten the socket
head screws.
Fig. 32
Fig. 33a
Fig. 33b