Evolution FURY62102, Original Instructions Manual

Page: 17 / 132

17
www.evolutionpowertools.com
EN
DE
FR
TR
GETTING STARTED
WARNING:
ALWAYS DISCONNECT THE SAW FROM THE POWER
SOURCE BEFORE MAKING ANY ADJUSTMENTS.
Refer to the “Service Parts Diagram”. Install a blade as detailed in
the “Installing or Removing the Blade” section.
Note:
We recommend that the operator reads the ‘Important
Information’ sticker applied to the table of the Fury6. Practicing
and becoming familiar with the procedures outlined on
this sticker will make subsequent adjustments/assembly or
configuring fairly straightforward.
PERMANENTLY MOUNTING THE FURY6 TABLE/MITRE SAW
(Fig. 1)
WARNING:
To reduce the risk of injury from unexpected saw
movement, place the saw in the desired location either on a
workbench or other recommended leg set. The base of the saw
has four holes to mount the mitre saw. If the saw is to be used in
one location, permanently fasten it to the workbench or leg set
using appropriate bolts with lock washers and nuts.
Note:
When permanently mounting the Fury6 we recommend that
the four (4) rubber feet located underneath each of the mounting
holes are removed and stored safely for possible future use.
1. Tighten the mitre and bevel locks.
2. Position the saw so other people cannot stand behind it.
Thrown debris could injure people in its path.
3. Place the saw on a firm, level surface where there is plenty of
room for handling and properly supporting the workpiece.
4. Support the saw so that the table is level and the saw does
not rock.
5. Bolt or clamp the saw to its support.
For Portable Use (Fig. 2)
Note:
The Fury6 is designed to be a highly portable machine.
For portable use the Fury6 must be fitted with
the two (2) rear Stabilising Arms.
Fig. 1
1) Hex headed bolt
2) Spring washer
3) Flat washer
4) Mitre saw base
5) Workbench
6) Flat washer
7) Spring washer
8) Hex nut
9) Lock nut
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(9)
Fig. 2