
EVOKO MINTO
USER MANUAL
9
Pair Device) as normal.
2.
When the device is connected
with Minto, press VOL + and BT
key simultaneous for 3 sec.
3.
There will be a confirm beep and
the device is now stored in Auto
Pair Memory.
The automatic pairing (160 sec) can
be interrupted by pressing the BT key
when Minto blinking blue =>“pairing
removed“ and Minto will go back to
Normal Mode. Next time Minto is
powered up it will try to Auto Pair
again.
The Auto Pair Mode can be de-
activated by pressing VOL+ and BT
just after Power Up and when Evoko
Minto is trying to Auto Pair, i.e. the
blue light is blinking. The Auto Pair
Device should not be on (if it is, it will
pair with Evoko Minto and de-
activation will not go through).
9.
Configuration from
the Evoko Control
Panel
In the Evoko Control Panel
software you are able to do
firmware upgrade.
Please visit
www.evoko.se/support
to download the Evoko Control
Panel
10.
Demo Mode
Available from the Minto SW version 4.7.0.
Demo Mode can be used to show and test the unit
without an active call.
Demo Mode is activated by:
Powering up the Minto without connected cables or
BT connection.
Press VOL– and Power keys simultaneously for 3
sec.
A positive beep is heard when Demo Mode is
activated. Minto starts automatically to clear the
memory and the Halo Light is breathing red until the
memory is cleared.
When the unit beeps and the Halo Light turns steady
blue it is ready to be used:
1.
Press BT key to start recording. The Halo Light
becomes steady green and will be recording for 12
sec.
2.
When 4 sec. is left of the recording Minto starts
flashing green.
3.
After 12 sec. the Minto beeps and automatically
plays back the recording while breathing blue.
4.
After the playback, the memory is cleared again and
when the Halo Light turns steady blue it is ready to
start a new recording (see step 1)
Demo Mode is de-activated by:
Pressing VOL– and POWER key simultaneously for 3
sec. or
Turning off the device
Summary of Contents for EM1001
Page 12: ...www evoko se...