EVOKO EM1001 User Manual Download Page 11

EVOKO MINTO

USER MANUAL

11

FCC Compliance

This device complies with Part 15 of the FCC Rules. Operation is

subject to the following two conditions: (1) this device may not

cause harmful interference, and (2) this device must accept any

interference received, including interference that may cause

undesired operation.

Warning:

Changes or modifications to this unit not expressly

approved by the party responsible for compliance could void the

user’s authority to operate the equipment.

NOTE:

This equipment has been tested and found to comply with

the limits for a Class B digital device, pursuant to Part 15 of the

FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installa-

tion. This equipment generates, uses and can radiate radio

frequency energy and, if not installed and used in accordance

with the instructions, may cause harmful interference to radio

communications.

However, there is no guarantee that interference will not occur in

a particular installation. If this equipment does cause harmful

interference to radio or television reception, which can be

determined by turning the equipment off and on, the user is

encouraged to try to correct the interference by one or more of

the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and

receiver.

Connect the equipment into an outlet on a circuit different

from that to which the receiver is needed.

Consult the dealer or an experienced radio/TV technician

for help.

Responsible party:

Evoko Unlimited AB

297 Kinderkamack Rd, Suite 200, Oradell, NJ 07649, USA

Tel.+1 201 261-5560

Evoko Minto - Model number EM1001.

Warnings:

“3.5 mm audio cables must be shorter than 3 meters.”

“The socket-outlet shall be installed near the equipment and

easily be accessible.”

“Excessive sound pressure from earphones and headphones

can cause hearing loss.”

CAUTION:

Danger of explosion if battery is incorrectly replaced.

Replace only with the same or equivalent type.

注意!

依據 低功率電波輻射性電機管理辦法
第十二條

經型式認證合格之低功率射頻電機,非經許

可,公司、商號或使用者均不得擅自變更頻率、加
大功率或變更原設計之特性及功能。
第十四條

低功率射頻電機之使用不得影響飛航安全及

干擾合法通信;經發現有干擾現象時,應立即停
用,並改善至無干擾時方得繼續使用。

前項合法通信,指依電信法規定作業之無線

電通信。
低功率射頻電機須忍受合法通信或工業、科學及醫

012-140014

Hereby, Evoko Unlimited AB declares that this conference phone is in compliance with the

essential requirements and other relevant provisions of directive 1999/5/EC. The declaration
of conformity may be consulted at: www.evoko.se/downloads

La operación de este equipo está sujeta a las siguientes dos condiciones: (1) es posible que

este equipo o dispositivo no cause interferencia perjudicial y (2) este equipo o dispositivo debe

aceptar cualquier interferencia, incluyendo la que pueda causar su operación no deseada

Summary of Contents for EM1001













Reviews: