EvoJet B110neo, Manual, Page: 23 / 43

B110neo – B170neo – B220neo – Instructions 6.0
lowB
The minimum voltage of the turbine battery has been reached and the safety limitation has
been activated (throttle can only up to 50 %, lowB). To receipt this, immediately throttle
down to idle and land the airplane. If the minimum system voltage is reached, a safety
shutoff takes place (lowB, lowB).
Solution: Charge the turbine battery and/or check the cables and plugs.
higB An overvoltage of the turbine battery has been detected.
Solution: Check the turbine battery, connect the right battery type and/or check the
AUTOSTART 46:BATTERY battery type settings.
R/C?
The RC1 remote control signal was not detected for a longer time than specified under
R/C-SETTINGS 57:FAILS-TIME, or the RC2 remote control signal was not detected for
more than one second.
Solution: Check the remote control system and do a transmission range test!
tolF
The sensors of the engine deliver invalid measurement signals. This means that the engine
can no longer be controlled and must be shut down (safety shutoff).
Solution: Charge the turbine battery and/or check the cables and plugs.
The trim down (below 50%=mid) removes the error codes and enables the jet engine again:
Restart the jet engine (keep a safe distance, see page 6!):
1. Throttle down + trim down (below 50%) => remove LOCK
2. Trim up => RUN – cleared
3. Throttle up and down again => AUTOSTART activated, see EDT display (page 11).
23