Jetronic-BOX HV Instructions 2.1
3/4/5:RC3/4/5-CONTROL – Settings for the Outputs RC3, RC4 and RC5
30:RC3-MODE
Specifies the basic function for the remote control output RC3.
OFF
:
The output is switched off and disabled.
RC1-DIRECT
for gears and doors that remain open (bistable function)
The remote control signal OFF/ON at the RC1 input switches the output between
the positions
IN
(retracted)=34:RC3-LOW and
OUT
(extended)=
36:RC3-HIGH.
RC1-TRIGGER
for doors that close again automatically (monostable function). An OFF
→
ON
change of the remote control signal at the RC1 input switches the output to the
position 36:RC3-HIGH for the times specified with 31:RC3-WAIT-OUT (RC1=ON).
An ON
→
OFF change of the remote control signal at the RC1 input switches the
output to the position 36:RC3-HIGH for the times specified with 32:RC3-WAIT-IN
(RC1=OFF). After this time, the output returns to the position 34:RC3-LOW.
RC1-TRIGGER-LOOP
(switchable endlessloop)
This function toggles the servo at RC3/4/5 automatically, as long as RC1 input is
switched. All settings 31 – 38 can be used to adjust.
The value 37:DELAY must always be equal or higher as the time for the end-
positions 31 and 32.
RC1-DIR.&POS.
works like RC1-DIRECT, but is logical AND'ed with the retracts position-switch.
For this 22:RC2-MODE must be set to POS.-SWITCH.
RC1-TRIG.&POS.
works like RC1-TRIGGER, but is logical AND'ed with the retracts position-
switch. For this 22:RC2-MODE must be set to POS.-SWITCH.
RC1-PROP
:
The output follows the remote control signal at the RC1 input proportional.
All settings 31 – 38 can be used to adjust.
15