KH407 7 TWIN BOOM
2.
BASE PIVOT POINTS
All pivot points will need to be lubricated with TAC-2 or similar lubricant. Simply
spray for 2 seconds on each side of the recommended points monthly.
The hoist has to be turned onto its side for access to the following lubrication points.
(To do this 2 people are required.)
Follow the instruction below:
2.0.1 Both people are to stand on one side of the hoist. One near the push
handle, the other by the side of the hoist.
2.0.2 The person near the push handle locks the total lock castors.
2.0.3 In conjunction with one another pull the hoist towards the side, lowering the
hoist onto its side on the floor.
2.0.4 The hoist can lie on its side without damage to the plastic cover, but care
must be taken when lowering/raising.
You now have access to all the lubrication points. ie: pivot points, leg lever
and leg pivot. Simply spray TAC-2 on all the pivot points for 2 seconds.
2.1
Leg Actuator Pivots (Fig 7)
Leg Pivots (Fig 7)
Tie Rod Pivot Points (Fig 7)
3.
ARM AND ACTUATOR PIVOT POINTS
The arm pivot points will need to be lubricated with TAC-2 or similar lubricant.
Simply spray for 2 seconds on each side of the recommended points monthly.
3.1
Arm Pivot (Fig 8)(Front & back)
3.2
Actuator Pivots (Fig 8)(Top & Bottom)
Fig 8
NOTE: TAC-2 is a CRC product and is available from most automotive outlets or from
Kerry Equipment.
