Evinrude FHL115, Operator'S Manual

Page: 13 / 62

10
- General Information
YOUR EMISSION CONTROL WARRANTY RIGHTS AND OBLIGATION
The California Air Resources Board and BRP are pleased to explain the emission control system warranty
on your
Evinrude outboard with Direct Injection. In California, new outboard engines must be designed,
built, and equipped to meet the State's stringent anti-smog standards. BRP must warrant the emission
control system on your outboard for the periods of time listed below provided there has been no abuse,
neglect, or improper maintenance of your outboard.
Your emission control system may include parts such as the carburetor or fuel injection system, the igni-
tion system, and catalytic converter. Also included may be hoses, belts, connectors, and other emission-
related assemblies.
Where a warrantable condition exists, BRP will repair your outboard at no cost to you, including diagnosis,
parts, and labor, provided that such work is performed by an authorized BRP Dealer.
Manufacturer's Limited Warranty Coverage
This emission limited warranty covers Evinrude outboards with Direct Injection certified and produced by
BRP for sale in California, that are originally sold in California to a California resident, or subsequently
warranty registered to a California resident. The BRP North America Limited Warranty conditions for
Evinrude outboards with Direct Injection are still applicable to these models with the necessary modifica-
tions.
Select emission control parts of your Evinrude outboard with Direct Injection are warranted from the date
of purchase by the first retail consumer or the date the product is first put to use, whichever occurs first,
for a period of 4 years, or for 250 hours of use, whichever occurs first.
However, warranty coverage based on the hourly period is only permitted for outboards equipped with the
appropriate hour meters or their equivalent. If any emission-related part on your engine is defective under
warranty, the part will be repaired or replaced by BRP.
Parts covered are:
1. Electrical System 4. Air Induction System
A. EMM (Engine Management Module) A. Reed Valves
B. Spark Plugs and Wires B. Throttle Body Assembly
C. Ignition Coils C. Throttle Linkage
D. Wiring Harness
5. Oil System
2. Exhaust System A. Oil Injector
A. Powerhead to Lower Unit Adapter Plate B. Oil Lift Pump
B. Exhaust Pressure Fitting C. Oil Lines, Fittings, and Clamps
C. Inner Exhaust Housing
D. Exhaust Back Pressure Hose and Diaphragm 6. Sensors
E. Intake Manifold and Exhaust Manifold A. Air Temperature Sensor
B. Crank Position Sensor
3. Fuel System C. Throttle Position Sensor
A. Fuel Lift Pump D. Water Temperature Sensor (Port Cylinder Head)
B. Fuel Supply Pump E. Thermostat
C. Fuel Injectors
D. Vapor Separator 7. Gaskets
E. Fuel Lines, Fittings, and Clamps A. All Emission Component Gaskets