Evinrude E-Tec, Operator'S Manual

Page: 44 / 84

42
Using Your Evinrude E-TEC Outboard
PRE-RIDE INSPECTION
A
WARNING
Always perform a pre-ride inspection before operating the boat. Check the proper
operation of critical controls, safety features and mechanical components. Correct
any problems BEFORE leaving the dock. Make sure all safety equipment required by
local law is onboard.
ITEM OPERATION

Hull Inspect.
Propeller
Inspect condition of propeller. Repair or replace
damaged propeller.
Cooling system Inspect water intake screens.
Safety equipment Ensure safety equipment is onboard.
Oil level Check. Refill as needed.
Bilge Drain. Ensure drain plug(s) are securely installed.
Battery
Check battery connections are clean, tight, and
insulated. Ensure battery/battery box are secure.
Fuel level Check. Refill as needed.
Navigation lights Check operation.
Steering system Check operation.
Boat systems (horn, pumps, radio) Check operation.
Tether cord
Inspect condition. Attach tether cord to key switch
(remote control) or engine cut–off switch (tiller
control).
Operator’s Guide
Confirm this Operator’s Guide is onboard and
readily accessible.
Engine Start switch (tiller control) Test operation.
Engine cut–off switch (tiller control) Test operation.
Key switch (remote control) Test operation.
Engine Cut-off Switch/ Tether Cord
Test operation. Reattach tether cord to key switch
(remote control) or engine cut–off switch (tiller
control).
Shift and Throttle Check operation.
Cooling system Confirm operation (water pump indicator).