EVGA Corporation 2900 Saturn St. Suite B, Brea, CA 92821
Phone: 888 / 881-EVGA - 714 / 528-4500 - Fax: 714 / 528-4501
Page 24
Secondary IDE Connector (40-pin block): IDE2
This connector connects to the next set of Master and Slave hard disks. Follow
the same procedure described for the primary IDE connector. You may also
configure two hard disks to be both Masters using one ribbon cable on the
primary IDE connector and another ribbon cable on the secondary IDE
connector.
Secondary IDE Connector
Pin 1
IDE2
Two hard disks can be connected to each connector. The first HDD is referred
to as the “Master” and the second HDD is referred to as the “Slave”.
For best performance, we strongly suggest you don’t install a CD-ROM or DVD-
ROM drive on the same IDE channel as a hard disk. Otherwise, the system
performance on this channel will not be able to achieve its maximum ATA133
speed.
Serial-ATA Port connector: SATA1 / SATA2 / SATA3/ SATA4
This connector support the provided Serial ATA IDE hard disk cable to
connecting the motherboard and serial ATA hard disk. The motherboard will
support both SATA 150 and 300 standards.
Serial-ATA Port Connector
SATA2
SATA1
SATA4
SATA3