Everwell MGTC0913C-20, Service Manual

Page: 5 / 53

Note: Each mode and relevant function will be further specified in following pages.
Air Conditioner Service Manual
Remote Control
Note :
The remote controller is not presetting as Cooling Only Air Conditioner or Heat Pump by manufacturer.
Each time after the remote controller replace batteries or is energized, the arrowhead will flashes on the front of
Heat or Cool on LCD of the remote controller.
User can preset the remote controller type depending on the air conditioner type you have purchased as follows:
Press any button when the arrowhead flashes on the front of
Cool , Cooling Only is set.
Press any button when the arrowhead flashes on the front of Heat , Heat Pump is set.
If you don t press any button within 10 seconds, the remote controller is preset as Heat Pump automatically.
If the air conditioner you purchased is a Cooling Only one, but you preset the remote controller as Heat Pump, it
doesn
t bring any matter. But if the air conditioner you purchased is a Heat Pump one, and you preset the remote
controller as Cooling Only, then you CAN NOT preset the Heating operation with the remote controller.
Remote controller
1
2
4
3
5
6
9
7
MODE button
ECO button
ON/OFF button
FAN SPEED button
TEMP UP button
TIMER button
SLEEP button
TEMP DOWN button
To select the mode of operation
.
In cooling mode,press this button ,the temperature
will increase 2
on the base of setting temperature:
In heating mode, press this button, the temperature
will decrease 2
on the base of setting temperature.
To switch the conditioner on and off.
To select the fan speed of auto/low/mid/high.
To set automatic switching-on/off .
Increase the temperature or time by 1 unit.
To activate the function SLEEP
.
Decrease the temperature or time by 1 unit.
4.Operation Details
8
SUPER button
In cooling mode, press this button, the unit will give
the maximum cooling temperature with 16
In heating mode, press this button, the unit will give
the maximum heating temperature with 31
.
9
SWING button
10
To activate or deactivate of the movement of the
DEFLECTORS
.
12
DISPLAY button
To LED display (if present)
.
switch on/off the
9
3
4
2
1
9
5
6
7
8
10
11
12
9
CLOCK
11
Press this button to set the time. When the time is flashing,
press
! or ! to adjust the time. Every press equals one
minute,or press and hold for rapid adjustment. Press
CLOCK again once the time has been set.
.
13
14
12
3D
9
13
When you press "3D", the horizontal and vertical
vanes will swing together at the same time.
12
14
HEALTHY button
To switch - on /off HEALTHY function. It is a button
which controls the ionizer or plasma generator only
for inverter type.
4