evertz EQT Series, System Manual

Page: 22 / 76

EQT Router User Manual
Page 8
Revision 1.9.1
1 2
9 10 11 12 13
3 4 5 7 6
14 15 16
8 2
9 10 11 12 13
3 4 7 6
14 15 16
8
REF
Q-LINK
5 1
ETHERNET
10/100 LN/ACT
SERIAL
REF
LOCK
Q-LINK
ERROR
PWR1
GEN ERROR
PROC OK
PWR 2
ALARM
P
O
W
E
R
S
U
P
P
L
Y INPUTS OUTPUTS
P
O
W
E
R
S
U
P
P
L
Y
CAUTION
TO REDUCE RISK OF ELECTRIC SHOCK, GROUNDING CENTER
OF POWER SUPPLY CORD MUST BE MAINTAINED
CAUTION THIS EQUIPMENT HAS MORE THEN ONE POWER SUPPLY. TO REDUCE THE RISK OF
ELECTRIC SHOCK DISCONNECT BOTH POWER SUPPLY CORDS BEFORE SERVICING.
Figure 2-2: EQT Rear View (EQT-1616 and EQT-1604)
Figure 2-3: EQT Rear View (EQT-1602-CS (Newer Rear Plate))
Figure 2-4: EQT Rear View (EQT-3204-CS and EQT-3224 (Newer Rear Plate))
2.3.1. Video Inputs and Outputs
These connections are made using standard 75
Ω
video BNC connectors. A high quality coax cable
such as PSF1/2 (TF3255) for analog video, PSF1/3 (TF3304) for SDI video, Belden 8281 or 1694 for
SDI-HD video or suitable equivalents should be used for optimum performance.
It is both important and good practice that cables are properly supported and
not hanging on the connectors as this can put unnecessary stress on the
connectors and possibly reduces their working life.
2.3.2. Video Reference
Standard Definition and High Definition Video routers have a separate looping Ref input that takes any
standard analog video signal with standard sync. In addition, High Definition routers will also accept a
tri-level sync.

Note: The Video Reference feature is only available on the coax version.
Video reference is not available on the –F fiber version.
2.3.3. Fiber Input and Output Connections (EQT-3232-3G-F ONLY)
These connections are made using standard LC fiber connector ends on single mode. There are 32
fiber inputs and 32 fiber outputs on the EQT rear panel. A high quality fiber cable such as Corning
SMF-28 or suitable equivalents should be used for optimum performance.