evertz EQT-1616-3G-C, User Manual

Page: 35 / 102

EQT-1616-3G-C-C
EQT 12G/3G/HD Router
Page 23
The programmable GPOs are used to trigger alarms or to provide a limited tally capability. The GPOs
will be in the de-energized state when the power is off, so all the contacts will be closed.
Once the GPO is enabled through the Web page (Section 6.8.2) or VistaLINK® (Section 7.8.2), the
orientation can be changed from Normally Open to Normally Closed.
Also, the GPOs can be individually encoded to work independently or collectively:

Individual Function:
The four GPOs can be triggered independently, depending on the selected
function assigned to a specific GPO set, whether it is PSU Fault, Temperature Fault, Video Src
Missing and Video Route Selected (i.e.: in case, PSU Fault is attributed to GPO1, then once the
fault is present, GPO1 will be triggered, from 0 to 1).

Encoded Function:
The four GPOs can be encoded as a single integer value, identifying the
associated source of the destination set in the Web page or VistaLINK®. These bits of integer
value are identified as a source. A GPO value of 0000 Binary (GPO1 as the LSB) equated to
source 1 and a value of 1111 Binary equated to source 16.
Table 4-2 : Standard GPO Encoding Functions

NOTE: Each GPO correlates to two physical output pins – see Table 2-6 and
Figure 2-3.
.
FUNCTION GPO4 GPO3 GPO2 GPO1
Source 1 0 0 0 0
Source 2 0 0 0 1
Source 3 0 0 1 0
Source 4 0 0 1 1
Source 5 0 1 0 0
Source 6 0 1 0 1
Source 7 0 1 1 0
Source 8 0 1 1 1
Source 9 1 0 0 0
Source 10 1 0 0 1
Source 11 1 0 1 0
Source 12 1 0 1 1
Source 13 1 1 0 0
Source 14 1 1 0 1
Source 15 1 1 1 0
Source 16 1 1 1 1