evertz EMR-32x32-3G, Manual

Page: 17 / 46

EMR-32x32-3G
EMR 12G/3G/HD Router
Revision 1.2
Page 9
4. OPERATION
4.1. SYSTEM OVERVIEW
The EMR router is a matrix router that provides a simple, cost-effective solution for small router
applications. The EMR-32x32-3G consists of 32 equalized inputs and 32 reclocked outputs. Each input
and each output is interfaced through a common crosspoint that is controlled by the main processing
unit.
The processing unit interfaces the various control options such as Ethernet and serial with the
crosspoint, allowing full control of the routing resources. The processing unit also provides a video
reference to the crosspoint to maintain SMPTE switching on the switch line.
4.2. SYSTEM CONFIGURATION
4.2.1.
Setting the IP Address
When shipped from factory, the default IP address of the device is as follows:
Router Component (EMR): 192.168.245.17
To change the IP address of the components via Ethernet, follow the instructions below:
1. Telnet to port 23 of the EMR IP address
2. Log in using login/password combination
customer/customer
3. Once the configuration menu is displayed, select the Network Setup menu
4. Follow the on-screen instructions to set the IP address, subnet mask, gateway, and broadcast
address
5. Make sure to select the option to Save and Exit when changes are complete
6. Wait 30 seconds for changes to be saved
7. Reboot the EMR for changes to take effect
To change the IP address via Serial connection, follow the instructions below:
1. Connect a DB-9 cable with a WA-S76 serial adapter to the SERIAL pin header on the edge of
the card
2. Set connection parameters as follows:
a. Baud rate: 115200
b. Data: 8 bit
c. Parity: none
d. Stop: 1 bit
e. Flow control: none
3. When prompted, log in with login/password combination customer/customer
4. Once the configuration menu is displayed, select the Network Setup menu
5. Follow the on-screen instructions to set the IP address, subnet mask, gateway, and broadcast
address
6. Make sure to select the option to Save and Exit when changes are complete
7. Wait 30 seconds for changes to be saved
8. Reboot the EMR for changes to take effect