evertz CP-1024E, User Manual

Page: 18 / 28

CP-1024E
Control Panel
Page 10
Revision 1.1
4.3.3.2. Setting the Dual PSU Mode
The user can enable or disable the Dual PSU Mode by selecting the Dual PSU Mode option.
Use the
Menu rotary encoder to toggle to the Dual PSU Mode menu item. To select yes or no, rotate
the encoder clockwise (down) or counter-clockwise (up) to highlight the desired menu item.
Yes - Enables the Dual PSU Mode
No - Disables Dual PSU Mode
Once the Dual PSU Mode is set, use the
B2 button to return to the setup sub-menu and then apply the
changes by selecting the Save Changes option.
4.3.3.3. Saving Changes
Once all the appropriate changes have been made in the setup menu, toggle to the Save Changes
menu item and push in the encoder when this option is highlighted. The changes that were made and
saved will be listed in the third display screen.
Please note that when changes have been made to the setup, the
B4 LCD button will be illuminated to
indicate that the setting has been changed. Once the user uses the Save Changes button to apply the
changes to the control panel, the B4 button will no longer be illuminated.
4.3.3.4. Revert Changes
The Revert Changes option can be used when changes have been made in the setup menu but the
user no longer wants to apply these changes and wishes to revert to the original settings. As long as
the changes have not been saved, the user can revert back to the original settings by toggling to the
Revert Changes option and pushing in the rotary encoder to revert back to the previous values.
4.3.4. Performing a SHAFT Test
Entering the SHAFT Test mode enables the user to test the rotary encoders on the front and rear of the
CP-1024E control panel. To enter Shaft Test mode, toggle to the SHAFT Test option and push in the
rotary encoder.
The second display window will populate. The following is a list of the items displayed on the second
screen. Each number corresponds to a shaft encoder; the following table identifies the corresponding
number and shaft encoder:
Screen Display Shaft Encoder
Shaft Test
0: 0,0,0
1: 0,0,0
2: 0,0,0
3: 0,0,0
4: 0,0,0
5: 0,0,0
Top Left Encoder (TL)
Bottom Left Encoder (BL)
Top Right Encoder (TR)
Bottom Right Encoder (BR)
Menu Encoder
Setup Encoder on rear panel
The purpose of this test is to check the general functionality of each individual encoder. Watch the
display as you turn and push each encoder; the values on the screen should change for the