7880IPG-NAT Series
High Density Network Address Translator
Page - 12
Revision 2.1
2.5.1.1.1.
SNMP V3 User Setup
The
SNMP V3 User Setup
menu defines basic access rules for the SNMP V3 protocol, controlling the
ability to read (“GET”) or read/write (“SET”) parameters. It also provides the password key for
authentication as well as AES or DES encryption. A maximum of ten different users can be entered.
Add New User
Add
New User
and
Edit User
will provide the same interface.
User Name
This is mandatory
.
User Type
Default is READONLY, Options are READONLY, READWRITE
This defines the access mode for the specific user.
Authentication
Default is NONE. Options are NONE, MD5, or SHA-1.
Authentication to check integrity of the incoming messages.
Authentication
Password
If Authentication is not set to NONE then this field is mandatory,
otherwise, Authentication will be automatically set back to NONE.
The password must be at least 8 characters long.
Use Privacy
Default is NONE. Options are NONE, AES, or DES. Use Privacy
will encrypt incoming and outgoing messages.
Encryption
Password
If Use Privacy is not set to NONE then this field is mandatory,
otherwise, Use Privacy will be automatically set back to NONE. The
password must be at least 8 characters long.
Included OID 1
These options are optional. They define the OID tree that the user
is restricted to access. The user can not access any other OID that
is not listed or included in the OID tree specified.
Edit User
Remove User
Removes previously entered users. This will affect the SNMP V3 Trap setup
as well. Please refer to next section for details.
Show All
SnmpV3 User
Lists all entered users. It will show username, access type, authentication
type and password, privacy type and password as well as included OIDs.
Once the
SNMP V3 User Setup
parameters have been configured, exit
SNMP V3 User Setup
by
pressing
X
then
<Enter>
.
