Troubleshooting
Table below lists typical problems encountered:
ymptom
loodhght does not
turn on for 5 seconds
after power is
connected.
annot carry out
inclusion and
association
t as es on
and off
ave contro ler
cannot communicate
with the unit
oodlight remains on
oss e ause
ower is not
connected properly
oodlight alrea y
paired to another
Z-Wave Controller.
ut o range.
etector
triggered by
unknown heat
source.
ecommen at on
ec
wall switch is on.
Confirm wiring is correct.
Check supply breaker / fuse.
e orm a actory reset.
e unit's ux sensor is being tnggere o y
reflected li ht
2.
2.
elocate the contro erc ser to e unit.
Install a Z-Wave repeater such as smart
plugs or other AC devices that can operate
as a Re ater.
heck time setting
Cover its PIR Detector with black insulating
tape. If after the timer expires and the
floodlight turns off this indicates that the PIR
Detector can see a moving heat source e.g:
radiator, heater, boiler outlet. open window,
open exterior door or moving branches or
bushes retaining heat from the daytime
eriod.
Manual Inclusion/Exclusion
The table below lists the several steps involved when adding or removing the unit from the
Z-Wave network.
Action/Status
No node ID
Auto Inclusion
Manual Inclusion
Exclusion
Factory Reset
(This procedure
should only be used
when the controller
is inoperable.)
Description
The Z-Wave Controller does not allocate a node
ID to the unit.
The power is applied for the first time and no
node ID has been stored in the module, or after
executing reset.
1.
2.
1.
2.
1.
2.
3.
Put the Z-Wave Controller into inclusion
mode.
Press the tamper switch 3 times within 1.5
seconds to put the unit into inclusion mode.
Put the Z-Wave Controller into exclusion
mode.
Press the tamper switch 3 times within 1.5
seconds to put the unit into exclusion mode.
Press the tamper switch 3 times within 1.5
seconds to put the unit into exclusion mode.
Within 1 second of step 1, press the tamper
switch again and hold until LED is off (about
5 seconds .
Node ID is excluded. The device reverts to
LED indication
2-second on. 2-second off
for 2 minutes.
LED blinks rapidly during
Inclusion, LED stops
blinking when Inclusion is
com lete.
LED blinks rapidly during
Inclusion, LED stops
blinking when Inclusion is
complete
factory default state and will be in
auto-inclusion mode for 4 minutes.
x Failed or successful results in including/excluding the ID can be viewed on the Z-Wave Controller.
9
